Retarding mechanism: turbine worm reducer

1. The reducer is made of high quality aluminum alloy die-casting housing, lightweight and beautiful appearance, compact structure, small volume, light weight, save installation space, is not easy to rust.

2. The cooling performance is good, safe and reliable, high efficiency.

3. The high bearing capacity, stable transmission, small vibration, low noise.

4. Has the power input and the output torque of the connecting structure, can meet the needs of a variety of connection;Body shape design and foot hole set layout to adapt to a variety of installations, strong commonality.

Installation note:

1. Reducer shall be installed on the flat solid base for the foot screws must be tightened and shock.

2. The prime mover speed reducer - all the connecting shaft extension machine work, must be accurate to each other after installation on the axis.

3. The sprocket, gear transmission parts such as shaft extension, should as far as possible close to the bearing, to reduce the axial and bending stress.

4. The reducer assembly machine, wall should be distributed in the head of the worm and keyway butter, avoid too tight assembly, prevent rust shaft hole day long.

5. The use of all kinds of motor straight type decelerate machine, if the motor weight is big, should be set up to support device.

Power: 500 w

Voltage: 12 v / 24 v

Turbine: NMRV050

Ratio: 5, 7.5, 10, 15, 20, 25, 30, 40, 50, 60, 80, 100

About the speed ratio corresponding to the following:

Ratio of 5-480 - RPM, the ratio of 7.5-320 RPM, 10-240 RPM speed ratio,Ratio of 15 to 160 r/min,

Ratio of 20-120 revolutions per minute,Ratio of 25 to 96 r/min, 30-80 RPM speed ratio,40-60 RPM speed ratio,

50-48 RPM speed ratio,60-40 RPM speed ratio, speed ratio, 80-30 r/min, the speed ratio in 100-24 revolutions per minute

Actual speed will change with the load size and 2-20% than the values shown in the error, 25 a 24 v theory parameters, 50 a 12 v theory parameters (current changes over load).If the other speed control of motor speed,Adjust the torque is abate, can't run at low speed for a long time

Turbine box dimensions corresponding to 050,

Output hole 25 mm

The motor flange diameter of 10.4 * 10.4 CM

Motor length is 19.5 CM